Nasco Specifications

Email Us
1-800-326-0274

SPECIFICATIONS

MODELS DN4W SERIES
ENGINE:
Diesel Powered John Deere PE-4045D
Type: Four cycle
No. Cyl.: Four
Displ: 276 Cu. In.
Bore: 4.19 In.
Stroke: 5.0 In.
Ratio: 17.6 to 1
Gross H.P. @ 2500 RPM 80
Peak Torque @ 1200 RPM 215 Ft. Lb.
Fuel Direct Injection w/Cold Start Aid

TRANSMISSION:
Four Speed Synchromeshed Power Shuttle with Torque
Converter, Electro-Hyd. Direction Shifter

DRIVE AXLE:
Heavy Duty with Planetary Reduction

DRIVEN STEER AXLE:
Steering Angle of 48". Compatible Differential Ratio with
Main Drive Axle Insures Optimum Ground Traction

STEERING:
Hydro-Static Power Supplied by 8 G.P.M. Gear Pump.
Maintaining Steering Load Lock to Lock.

BRAKES:
Hydraulically Operated By Foot Pedal. Oil Immersed Multiplate
Disc Mounted in Differential Housing. Manually Operated
Lever Lock Parking Brake.

ELECTRICAL SYSTEM:
12 Volt with 55 Ampere Hour Alternator, 650 Cold Cranking
Ampere Battery.

Hydraulic SYSTEM:
Gear Pump Delivers 20 G.P.M. @ Rated
Engine Speed. Hyd. Pressure Set @ 2500 P.S.I. with
Lever Operated Hyd. Control Value

FUEL TANK:
15 Gallons

MODELS DN4W-10, DN4W-12, DN4W-14,
DN4W-16
Drive 50x20-20 (24-32 PLY)
Steer 34.5 x 9.75-18 (22 PLY

MAST:
Mill Rolled Shaped Beam Contsruction, with Permanently
Sealed 5" Diameter Ball Bearings.

CARRIAGE:
60 Inch Width T1 Steel Cross Members, 5" Diameter
Solid Steel Rollers with 4" Diameter Side Thrust Rollers.

FORKS:
4 Foot Long with 2" x 5" Cross-section, Pallet Type Forks Mounted with Eyes onto Round Cold Steel Fork Shaft.

Copyright © 2005 Nasco Forklift Equipment Company All rights reserved.
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks
or registered trademarks of their respective companies or mark holders.
This site built and maintained by: Auto and Parts

ANY DATA SHOWN ON THIS WEB SITE MAY CHANGE WITHOUT NOTICE!!